gphp series single output power supply ? 90 -264 vac nominal input range ? overvoltage and short circuit protection ? approved to ul, csa and en standards ? power good led ? low leakage g gphp 600 shown in cra rack the gphp series are universal input ac/dc power supplies with power factor correction (pfc) with up to 700 watts ouput power. the gphp product in corporates hot-swap capabilities and a handle. the series is approved to en60950 to reduce design-in time and end system compliance costs input specifications input voltage range universal input 100-240 nom (85 - 264 max) vac input frequency 47 hz to 63 hz input surge current 25 a max. ground leakage current 264 vac 60 hz 160 m a input current 120 vac 8.5 a 230 vac 4.5 a input fuse f1,f2 10.0 a emc information conducted emissions fcc pt 15, en55022 level b radiated emissions fcc pt 15, en55022 level a line freq. harmonics en61000-3-2 class a voltage fuctuations en61000-3-3 complies (clause 5b) esd air en61000-4-2 8 kv contact esd contact en61000-4-2 6 kv air radiated immunity en61000-4-3 3 v/m fast transients (eft) en61000-4-4 2 kv 5 khz line surge immunity en61000-4-5 1 kv diff /2 kv cm conducted immunity en61000-4-6 3 vrms power freq. mag. feld en61000-4-8 3 a/m voltage dip immunity en61000-4-11 unit will ride through without loss of output at 75% of rated load with ac power fail warning. environmental specifications thermal performance operating ambient (see ratings chart) -20 o c -50 o c non-operating -40 to +85 o c 0 - 50 o c convection cooled 600 watts maximum altitude operating / non-operating 10,000 ft. / 40,000 ft. max. relative humidity non-condensing 5% - 95% rh vibration (operating) 0.003 g 2 /hz 1.5 g rms 3 axes 10 min/axis vibration (non-operating) 0.026 g 2 /hz 5.0 g rms 3 axes, 1 hr/axis shock half-sine 20 g pk 10 ms, 3 axes, 6 shocks total shock half-sine 40 g pk 10 ms, 3 axes, 6 shocks total ouput specifications output power integral forced air 700 watts max. total regulation see table rise time at turn-on 2.0 s max. transient response main output 25% 0.1 a/ m s 3.5% max. dev. 350 m s recovery to 1% temperature coef - fcient +/-0.03%/oc overvoltage protection 125% +/-10% short circuit protection block wall yes all specifcations are typical at nominal input, full load at 25 o c unless otherwise stated specifications high power supplies 600/700 watt ac/dc universal input power supply summary page 1 of 3
general specifications hold-up time 120 vac, 60 hz 30 ms at 600 watts output effciency 120 vac 600 w output >84 % isolation voltage input to ouput input to ground 4000 vac 1500 vac switching frequency fxed 70 khz, +/- 10 khz safety approvals ul/en/iec 60950-1 1st edition csa22.2 no.60950-1-03 maximum weight 2 kg (4.4 lbs) model number output peak output features ripple regulation GPHP600-24 24 v 25 a 24 v 27 a hot swap 240 mv 3% (see note 4) GPHP600-28 28 v 21.5 a 28 v 23.5 a hot swap 240 mv 3% (see note 4) GPHP600-36 36 v 17 a 36 v 19 a hot swap 240 mv 3% (see note 4) gphp700-48 48 v 14 a 48 v 15.6 a hot swap 240 mv 3% (see note 4) notes 1. integral forced air cooling 2. peak rating is for 1 minute maximum 10% duty cycle 3. noise measurent 20 mhz bandwidth, differential mode. measured with scope probe directly across output terminals of the power supply. 4. regulation includes provision for droop sharing power connector din # 41612 type h input pins z-32 ac line d-30 ac neutral z-28, d26 ground output pins z12, d14, z16,d18 output z4, d6, z8, d10 return (common) status & control pins z20 dc power good z24 inhibit d22 ac power fail page 2 of 3 mechanical notes the gphp series is factory confgured for rack mounting installation with condor cra series racks. other mounting confgurations and connector op - tions are available, please contact factory.
condor dc power supplies inc. 2311 statham parkway, oxnard ca, 93033, usa. phone:(805) 486 4565 fax:(805) 487 8911 email: condor@condordc.com GPHP600/700 revb 11/15/05. data sheet ? 2005 condor dc power supplies inc. the information and specifcations contained in this data sheet are believed to be correct at time of publication. however, condor accepts no responsibility for consequences arising from reproduction errors or inaccuracies. specifcations are subject to change without notice. solidworks is a trademark of solidworks corp. outline and mounting drawing other drawings and solidworks? 3d models are available on request. page 3 of 3
|
